General Finishes OIL BASED Wipe-On GEL STAINS

General Finishes OIL BASED Wipe-On GEL STAINS
Type: Oil Based
Non Ambering
Use: Interior
Raw Wood Application: *Note.
(*When working over an existing finish or painting on the stain
without wiping away, extended dry time and a unique preparation
and application approach are required.
Clean and de-grease first to make sure all waxes, oils, care products, and grease or grime contaminants on the existing finish are removed.
Test & Ensure compatibility between other brands in use.)

*EXCEPTION: Apply GRAY Gel Stain to Raw Wood Only for best results.

Can Sizes: Pints, Quarts, (on order Gallons)
Coverage: Quart, 125 Sq.Ft. --  Gallon, 500 Sq.Ft.
Viscosity: Very Thick

Application: Brush
Coats (#) Required: 1+
Hand Apply: Yes
Spray: No
Topcoat Required: Yes
Topcoats Recommended: Arm-R-Seal or Gel Topcoat

VOC: <550 g/L

RECOAT / DRY TIMES:
Preparation will affect this process - if there is wax on the surface, the finish may never adhere.
If Pledge has ever been used on a piece, there is silicone contamination, which is VERY difficult to remove.
Ideal drying conditions are 70 degrees Fahrenheit and less than 70% humidity.
If you are working outside in ideal conditions (avoid direct sunlight), be cautious about dry time.
Do not recoat until you are sure the stain is completely dry.
Other factors are -- 1) the surface you are applying the stain and -- 2) the application method.

On denser surfaces, such as an existing finish, the dry time will be longer.
A "painted" finish is thicker and will take longer to dry, than one that is wiped down or dry brushed.

Gel Stain over raw wood:
Dry Times:
To touch: 8 hr
To re-coat with stain: 24 hr
To apply oil-based topcoat: 24 hr  
To apply water-based topcoat: 72+ hr 
Before light use: 7-10 days
Cure time: 30 days

Gel Stain over an existing finish (wipe-away):
Dry Times:
Touch: 8hr
To re-coat with stain when "wiping off": 24 - 48+ hr
To apply oil based topcoat: 24 - 48+ hr
To apply water-based topcoat: 72+ hr
Before light use: 7-10 days
Dry-time over laminate or other non porous surfaces:
At least 72 hours or more. Test to your satisfaction before proceeding.
Complete Cure time: 30 days

Gel Stain over an existing finish (paint on):
DryTimes:
Touch: 8hr
To re-coat with stain when "painting on": 48 - 72+ hr 
To apply oil based topcoat: 24 - 48+ hr
To apply water-based topcoat: 72+ hr
Before light use: 7-10 days
Dry-time over laminate or other non porous surfaces:
At least 72 hours or more.
Test to your satisfaction before proceeding.
Complete Cure time: 30 days

Digitized colors shown are for reference purposes only.
Always test stain on a piece of the same wood or a hidden area of the project to verify your desired color.