Mohawk Finishing Products
Division of RPM Wood Finishes Group, Inc.
Product Data Sheet
Ultra-Flo™ Ultra Bond Clears (13 oz. aerosols)
M102-0550 (Gloss), M102-0551 (Semi-Gloss), M102-0552 (Satin), M102-0553 (Flat)
Product Description:
Ultra-Flo™ Ultra Bond Clears are specially formulated to adhere to and flow out
over hard to coat surfaces such as UV cure, two-component, polyester and other finishes.
Advantages:
1. Provides superior adhesion and flow.
2. HAP’s compliant.
3. MIR compliant.
4. Excellent blend-in properties.
5. Available in 4 sheens.
Characteristics:
Weight per gallon: 6.50 – 6.52 lbs/gal (including propellant)
Solids % (wt): 9.16 – 9.74
Solids % (vol): 5.71 – 5.96
Package viscosity: 23-26 seconds, #1 Zahn cup
Dry time:
Air dry @ 72 F, 35% relative humidity
To touch: 7 minutes
To handle: 15 minutes
To package: overnight
PWR category: CCP
PWR Category limit: 1.5
PWR of product: 0.988*
*Includes propellant; values vary between sheens
All values theoretical; not intended to be exact QC specifications.
Package life: 3 years
Sheen:
Gloss: > 80
Semi-Gloss: 60
Satin: 40
Flat: 25
HMIS: Health – 2, Flammability – 4, Reactivity – 0, Personal Protection – X
Specifications:
Directions:
Shake well before using.
Make sure surface is free of dirt, grease, etc., by cleaning with Wax Wash™ Remover Aerosol and a clean cloth. For best results, use only when can temperature is between 65 and 90 deg F. Shake can vigorously for at least one minute after ball rattles to ensure sheen consistency. Sand the surface with 320 grit sandpaper and clean excess sanding dust off of the surface. Test aerosol on an inconspicuous area prior to application to ensure compatibility with surface coating. Point opening of spray button toward object, holding can 12-14 inches away from surface. Press spray button firmly. Use steady even strokes while spraying.
Apply Ultra-Flo™ Ultra Bond Clear topcoat in light coats. Several thin coats give a better finish than one heavy application. Allow coating to dry between applications.
Clean spray button immediately after use by turning can upside down and pressing spray button for 5 seconds
or until no more product comes out. If clogging develops, remove spray button with twisting motion and clean.
DO NOT stick pin or other object into can. Gently replace button with a twisting motion with top of can and spray button pointed away from you. Discard empty can in trash pick-up.
DO NOT place in home compactor or burn.
Safety and Other Precautions: Read MSDS for precautions before using product.
Ultra-Flo Ultra™ Bond Clear
revision 8/8/12
|
